How To Check Engine Oil Level In Ford Ecosport

Ford EcoSport Engine Oil Change Guide
How to change the motor oil and supplant the filter on a 2013 to 2021 Ford EcoSport with the i.0L I3 engine.

EcoBoost 1.0L I3 Engine
Enhance Forepart of SUV
Partially Remove Dipstick This automotive maintenance tutorial was specifically written to aid owners of the 2d generation 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020 and 2021 Ford EcoSport compact SUV in irresolute the motor oil and replacing the oil filter on the EcoBoost turbocharged 1.0 liter inline three cylinder engine. (The procedure should be similar for the two.0L I4 and 1.5L I3 engines.)

Owners of other Ford or Lincoln vehicles such as the Fiesta, B-Max, Escape, Edge, Bronco Sport, Explorer, Trek, Transit, Focus, Mondeo, S-Max, Puma, Kuga, Endura, Everest, Ka, Figo, Endeavour, Aviator, Corsair, Nautilus and Navigator may besides notice these DIY instructions to be helpful.

A few uniform replacement oil filters with their function numbers include the following: Motorcraft FL-910S, Purolator PL10241, Royal Purple 341777, Denso 150-2010 and Mobil 1 M1-102.

The tools and other items needed to complete this procedure include a flooring jack with 2 jack stands or a pair of automotive ramps, a used oil grab container, a 13mm socket with a 3/8" bulldoze ratchet, a Lisle 63600 oil filter wrench (optional) and an automotive funnel.

The oil chapters specification for the EcoBoost 1.0L I3 engine in this 2020 EcoSport for an oil change with a filter replacement is four.4 U.South. quarts (1.1 gallon or iv.3 liters) of new SAE 5W-xx oil.

Please cheque your owner's transmission for the correct oil chapters specification and viscosity (oil weight) recommendation for your SUV. They may vary depending on the model yr, trim level, manual type and your region of the world.

The beginning steps are to bulldoze the SUV on to a level surface, shift the manual into "Park" and plow off the ignition.

Engage the emergency / parking brake and place wheel chocks on both sides of the rear tires to help forbid the car from moving.

It would be best to perform the oil change later on the vehicle was recently driven when the engine is still warm to help suspend whatever contaminants within the old oil and likewise to allow the old oil to bleed out more quickly.

Open the hood, partially remove the dipstick handle an inch or two and twist off the oil fill cap in the counterclockwise direction.

Twist Off Oil Fill Cap
Silver Metal Oil Pan
Rear of Oil Pan Set the oil filler cap aside in a safety place.

Partially pulling out the dipstick and removing the oil make full cap will help foreclose a vacuum from forming and allow the old oil to drain out more quickly.

Carefully heighten the front of the vehicle with the floor jack and securely back up it with at least two jack stands positioned under the frame rails.

I just raised the front passenger side of the vehicle for quick and like shooting fish in a barrel access to the oil pan, bleed bolt and oil filter.

Please do non solely rely on the floor jack to support the vehicle!

Slide under the front passenger side of the engine bay.

Locate the silver metallic oil pan.

Oil Drain Bolt - Rear
Oil Filter In a higher place Drain Bolt
Used Oil Grab Basin The silverish metal oil drain bolt is located at the lesser of the rear edge of the oil pan.

If you look directly up from the drain bolt, you'll see the oil filter situated just above the CV axle.

Position the used oil catch basin to only below the drain bolt.

Loosen Counterclockwise
Bleed Out Old Oil
Spin In Oil Drain Bolt Carefully loosen the drain bolt by turning it in the counterclockwise direction with the 13mm socket and a 3/8" drive ratchet.

Be careful when you lot remove the bleed commodities since the onetime oil might notwithstanding be hot plenty to burn your fingers.

Allow the old oil to drain out for at to the lowest degree a few minutes or until the menstruum slows downwardly to just an occasional drip.

Audit the former oil drain plug. If the washer (or "gasket") is damaged, replace it with a new one.

If the drain plug itself appears damaged, supplant information technology with a new one.

A compatible replacement aftermarket oil drain plug is the Votex DP001.

Clean off the expanse around the bleed hole with a clean newspaper towel or a rag. Make sure the old washer is not however attached to the engine.

Spin in the bleed commodities a few turns by hand in the clockwise management to help foreclose it from becoming cross threaded.

Tighten Oil Drain Commodities
Lisle Oil Filter Wrench
Loosen Quondam Oil Filter Tighten the oil drain bolt in the clockwise direction with the 13mm socket and a three/eight" drive ratchet until information technology is snug.

If y'all have a reliable and authentic torque wrench, the service transmission specification for tightening the oil bleed bolt on the EcoBoost 1.0L I3 engine is 21 lb-ft (or 28 Nm).

Slide the used oil catch bowl to just below the old oil filter.

Spin off the old oil filter by twisting information technology in the counterclockwise management.

I highly recommend using an oil filter wrench such equally the Lisle 63600.

Information technology makes removing stubborn, stuck and overtightened oil filters much easier to remove.

Attach the oil filter wrench to a short extension bar and the 3/8" drive ratchet.

Loosen Counterclockwise
Drain Old Oil From Filter
Dip Finger In New Oil Advisedly spin the old oil filter in the counterclockwise direction until the old oil starts to drip out.

Allow the sometime oil to slowly drip out for a minute or 2 before fully removing the oil filter to foreclose from making a mess.

Completely spin off the erstwhile filter, bleed out the old oil into the bowl and discard it.

Dip your pinky finger into some new oil and lubricate the condom o-ring gasket on the new oil filter.

Lubricate Rubber O-Band
Spin On New Oil Filter
Tighten Oil Drain Commodities Lubricating the rubber o-ring volition assistance prevent oil leaks, allow the gasket to form a meliorate seal and also make information technology easier to remove the filter during the next oil change.

Make sure the old safety gasket is not still fastened to the engine.

Spin on the new oil filter in the clockwise direction until it is snug.

Continue tightening the new oil filter to about ane/2 to 3/4 of a turn past finger tight.

Try to avoid over tightening the new filter to prevent from damaging the rubber o-ring which could result in an oil leak.

(I've never used a torque wrench to tighten a new oil filter, merely the store transmission torque specification for tightening the new oil filter is nearly 11 lb-ft or 14.v Nm.)

Double bank check that the drain bolt and the new oil filter are tight before moving on to the next steps.

Lower SUV From Stands
Insert Automotive Funnel
Cascade In New Oil Carefully lower the SUV from the jack stands by using the floor jack.

Insert the automotive funnel into the oil fill port.

The oil capacity specification in the 2020 EcoSport owner's manual for the EcoBoost 1.0L turbo I3 engine for an oil change with a filter replacement is four.4 U.Southward. quarts (1.ane U.S. gallon or 4.3 Liters).

The owner'due south transmission recommends using SAE 5W-20 oil weight (viscosity) for almost climates.

Please bank check the owner's manual for your SUV to verify the right oil capacity specification and oil weight recommendation for your climate.

It is much ameliorate to have slightly less oil than necessary in an engine than to overfill it. Running an engine that has been overfilled may cause impairment to seals, gaskets or other components.

I recommend at first only pouring in about 4 U.South. quarts (or 4 liters) of new oil to assistance ensure the engine is non overfilled.

Temporarily supplant the oil fill cap and push the dipstick downwards into identify.

Beginning the engine and allow it warm up for a few minutes until it reaches normal operating temperature.

Turn off the ignition and let the new oil to drain back downward to the oil pan for at to the lowest degree 15 minutes for the most accurate dipstick reading.

Check Dipstick Oil Level
Replace Oil Make full Cap
Push button Downwardly Dipstick Pull out the dipstick, wipe it clean with a paper towel, fully re-insert it back into the engine and pull it out once again to check the oil level.

If necessary, slowly pour in more new oil upwards to the 4.iv U.Due south. quarts total chapters specification and repeatedly check the level on the dipstick.

Yous may not need to cascade in the entire 4.4 U.S. quarts for the oil level to reach the upper notch on the dipstick which indicates the "MAX" (maximum) level.

Once the oil level is correct, fully re-insert the dipstick and make sure the oil fill cap is tight.

Be sure to write downwardly the oil change and filter replacement in your vehicle's service records.

The EcoSport is equipped with an "Intelligent Oil-Life Monitor" system that volition indicate when an oil change is required. The service interval could be anywhere from almost three,500 miles for farthermost duty such as towing in the mountains to almost 12,500 miles for mostly highway driving on flat roads.

To reset the oil change indicator, follow these steps: 1. Switch the ignition to the "ON" (accessory) position but do not start the engine. 2. Fully press down the accelerator (gas) pedal and the brake pedal at the same time. three. Keep the accelerator and brake pedals fully pressed down at the aforementioned time. 4. After about three seconds, you will come across a message confirming that the reset procedure is in progress. v. After nigh 25 seconds, a message will announced confirming that the residue has been completed.

It would be a good idea to check your parking spot, driveway or garage for drops of fresh oil during the side by side few days which might indicate a leak from the bleed commodities or the new oil filter. I besides recommend checking the oil level on the dipstick afterward a few days and at least one time a month to monitor whatever oil consumption (oil being burned).

For more, check out all of the 2013-2021 Ford EcoSport DIY Repair & Maintenance Guides.

Source: https://www.paulstravelpictures.com/Ford-EcoSport-EcoBoost-1L-I3-Engine-Oil-Change-Guide/index.html